The current #digrig is about as good as I could ask for. Truck is a 212" wheelbase, 13 speed, CAT 3406C with marine cylinder packs at around 600HP, 8" pipes, and 3.90 rears on Neway air ride. Inside has 18" steering wheel, black dash/panels, and Bostrom Wide Ride seats. I cut the sleeper cut out much bigger to allow the seats to fully recline. I gutted the sleeper interior and built the custom interior with a bench seat, storage compartments, and subs. When doing all the body work I cut in a Peterbilt rear window which helps out when reversing the trailer and ads to the flat top look. Trailer is a 2017 Eager Beaver RGN that was custom ordered and built to be short with just an 18' well, upper haul deck, air ride, high clearance gooseneck, all center beams were recessed, full length exp. metal lower floor, boom well between the rear frame for the stick to clear, beaver tail with spring assisted ramps front and rear, Honda pony motor, and LED strobe lights. This setup will get in some pretty tight places that my last standard length lowboy behind the 379 would not. It's made a big difference with the shorter lowboy and a 212" wheelbase. Trailer ride height is adjustable using the leveling valve and height plates. Being a non ground bearing RGN you can raise the hydraulics up in the neck to get the trailer higher in case of an emergency or if more clearance is needed.
Now we have two 2017 CAT CR excavators loaded for a gross weight of 79,500 lbs. and a total height of 13'2". Trailer can also haul a 70,000 lb. machine with a permit. Machines can load from the front, rear, or side load if needed. Having rubber tracks allows me to walk on streets and driveways without causing damage and if my rig can't access the job I can walk the excavator down the street and remote park the rig. Also the blade box tool carrier I custom built fits on the trailer nicely and has been great in every way. #digrig #dreamrig #thesetup #toolsthatearn #lowboy #eagerbeavertrailers #fordltl9000 #flattop #13speed #18speed #catdiesel #cat3406 #catc15 #caterpillarmachines #caterpillarequipment #builtforit #builttoearn #borntowork #hardwork #itsnoteasy #itsrewarding #blessed #fortunatetohavework